The identifier of the trailing equipment and attached implements with an inclinometer

The identifier of the trailing equipment The device consists of two blocks which are installed on moving element and stationary part of the equipment and by angle change between them allow to determine in the on-position or off-position the trailing equipment and attached implements are situated. This information is displayed in the dispatching software and allows to exclude technological moving at calculations of the treated area.   The identifier of the trailing equipment and attached implements with an inclinometer

                        Scheme_AGRO_tractor.jpg

 

 

Technical characteristic

Parameter description     

Value
 Operating temperature range, °Ñ  – 40 … + 75
 IP protection degree  IP 67
 Measured angles range, degrees  ± 180
 Accuracy grade of angle measurement, degrees  ± 0,1
 Acceptable deviation angle of the actuator rotation plane from the vertical with account for bend of transport vehicle, degrees  ± 25
 Power voltage, operation range, V  9...36
 Rated current draw, mA  50
 Exchange rate through the serial port, bit/s   2400, 4800, 9600, 19200, 38400, 57600, 115200
 Programming interface  RS-232; RS-485
 Outside dimensions (with brackets), mm:  
             - master unit:  192õ69õ81
             - slave unit:  95õ59õ35
             - tractor slot:   115õ100õ79