The identifier of the trailing equipment and attached implements with an inclinometer
|
|
 The device consists of two blocks which are installed on moving element and stationary part of the equipment and by angle change between them allow to determine in the on-position or off-position the trailing equipment and attached implements are situated. This information is displayed in the dispatching software and allows to exclude technological moving at calculations of the treated area.
Technical characteristic
|
Parameter description
| Value |
| Operating temperature range, °С |
– 40 … + 75 |
| IP protection degree |
IP 67 |
| Measured angles range, degrees |
± 180 |
| Accuracy grade of angle measurement, degrees |
± 0,1 |
| Acceptable deviation angle of the actuator rotation plane from the vertical with account for bend of transport vehicle, degrees |
± 25 |
| Power voltage, operation range, V |
9...36 |
| Rated current draw, mA |
50 |
| Exchange rate through the serial port, bit/s |
2400, 4800, 9600, 19200, 38400, 57600, 115200 |
| Programming interface |
RS-232; RS-485 |
| Outside dimensions (with brackets), mm: |
|
| - master unit: |
192х69х81 |
| - slave unit: |
95х59х35 |
| - tractor slot: |
115х100х79 |
|
